UINICS LV1000 Series, Instruction Manual

Page: 13 / 67

- 9 -
６.Names and functions of components on front
Fig.14
① Display unit（Rad）（A-E）
1）Measurement value indicated at the time of measurement state.
2）Initialization
A-E：「 （A,B are blanks.）， 」is indicated.
3）Set list display
A ：Blank
B-E：「 （Pr.St）， （Md.St）， （SC.St），
（Ln.St）， （P8.St）」is indicated.
4）Mode set, Adjusting the analog mode set.
A ：Setting No is indicated.
B-E：Setting value is indicated.
5）Scaling value, Preset value, 8 step preset value, setting.
A ：“－”，“0-9”is indicated.
B-E：“0-9”is indicated.
6）Linearization setting.
・At the title indicated.
A-E：「 （Ln.01A）～ （Ln.21A） ，
（Ln.01b）～ （Ln.21b）」is indicated.
・At the setup indicated.
A ：“0-1”is indicated. （Ln.01A ～Ln.21A setting state）
：“－”，“0-9”is indicated.（Ln.01b ～Ln.21b setting state）
B-E：“0-9”is indicated.
7）Mode protect setting.
A-E：「 ， 」is indicated.
② Bar meter(Orange, White)
Measurement state：LEDs (0 -100%) turn on or off according to the rate value every 5.0%.
Over 100.0% (over 100.1%): all LEDs will blink.
Under 100.0% (under -0.1%): the least significant LED will blink.
Setting state：All LEDs turn off.
③-⑥ Preset output lamp（Red）（1-4）
Measurement state：It lights up OUT1-4 at the presetting output.
Setting state：The output lamp setting it now lights when the preset value is set.
The output lamp lights or blinks by each setting when scaling is set.
The output lamp lights or blinks by each setting when 8 presets value is set.
⑦ EXT. input lamp (Green）（HD）
Measurement state：The EXT.input (the terminal board 6-7th) is input, it lights.