UINICS LV1000 Series, Instruction Manual

Page: 31 / 67

- 27 -
ENT
ENT
ENT
１１.Mode setting method
≪The call method≫
1. It will became「 」display if“ “is pushed 2 sec or more.（Set list）
2. It will became「 」display if“ “is pushed once.
3. If is pushed, it will become a mode setup and can perform a setup of measurement operation.
≪Method of operating key to mode setting≫
Operation key Display The contents of operation
Ａ Ｂ Ｃ Ｄ Ｅ
０． ０ ０ ０
↑
Mode No.
１ ２ ３ ４
○ ○ ○ ○
Hold ％
○ ○
Mode No. is changed. There is a mode up to d.
┌ →０→１→・・・→ｄ→ ┐
└────────────┘
Whenever it presses a , the mode No changes in order.
〔Ascending order operation〕
Whenever it pushes ,pushing ,the mode No changes
conversely. 〔Descending order operation〕
The mode No.b is indicated with the option of P10 and P12.
The mode No.C and d is indicated with the option RS4(W).
Ａ Ｂ Ｃ Ｄ Ｅ
０．
０ →０→０
↑ │
└←─←┘
１ ２ ３ ４
○ ○ ○ ○
Hold ％
○ ○
Moves the flash figure when each setting, to the right.
Whenever it pushes once, it moves to the right.
Ａ Ｂ Ｃ Ｄ Ｅ
０．０ ０
０
↑
└0 to 3
１ ２ ３ ４
○ ○ ○ ○
Hold ％
○ ○
When pushing. Change the blinkig numeral value.
Every press raises the value by ones.
┌ →０→１→２→３→ ┐
└────────────┘
When pushing. Change the blinking numeral value.
Every press reduces the value by ones.
┌ →３→２→１→０→ ┐
└────────────┘
＜Caution＞
Numerical change is different for every setting item.
There are some which go up to a maximum of 9.
Please set up the required part to mode №ｄ.
in the procedure.
Ａ Ｂ Ｃ Ｄ Ｅ
Ｐ ｒ．Ｓ ｔ
１ ２ ３ ４
○ ○ ○ ○
Hold ％
○ ○
The setting value is registered by key and returns to
a setting list.
Ａ Ｂ Ｃ Ｄ Ｅ
Ｐ ｒ．Ｓ ｔ
１ ２ ３ ４
○ ○ ○ ○
Hold ％
○ ○
Returns to a setting list.
Unlike a key, set value is not registered.
Mode
RST
Mode
Mode
While
pushing
Mode
Mode
Mode
！