UINICS LV1000 Series, Instruction Manual

Page: 60 / 67

- 56 -
Ａ Ｂ Ｃ Ｄ Ｅ
(-)
９ ９ ９ ９
↑
└０to９
１ ２ ３ ４
● ○ ○ ○
Hold %
○ ●
<Programming displayA>
Ａ Ｂ Ｃ Ｄ Ｅ
(-)
９ ９ ９ ９
↑
└(-),Blank
When pushing. Change the blinkig numeral value.
Every press raises the value by ones.
┌ →０→１→・・・→９→ ┐
└────────────────┘
When pushing. Change the blinking numeral value.
Every press reduces the value by ones.
┌ →９→８→・・・→０→ ┐
└────────────────┘
The display for indication A can be set up (-: minus).
The display range of the display for indication B to D
is 0 to 9.
<Programming display A>
It is able to program “-(minus)”indication for display
A.When programming, B – F displays turn on and off.
┌ ⇔ (-) ⇔ Blank ⇔ ┐
└────────────────┘
Ａ Ｂ Ｃ Ｄ Ｅ
９ ９ ９ ９
１ ２ ３ ４
○ ● ○ ○
Hold %
○ ●
When pushed. It will become ch2 setup.
Please use the preset value of hope by and .
ch3 and ch8 setup are also the same.
Ａ Ｂ Ｃ Ｄ Ｅ
Ｐ ｒ．Ｓ ｔ
１ ２ ３ ４
○ ○ ○ ○
Hold %
○ ●
Set value is registered by a and it returns to a set
list display.
Ａ Ｂ Ｃ Ｄ Ｅ
Ｐ ｒ．Ｓ ｔ
１ ２ ３ ４
○ ○ ○ ○
Hold %
○ ○
Returns to the set list display.
Set value is not registered.
Ａ Ｂ Ｃ Ｄ Ｅ
Measurement indicat
１ ２ ３ ４
○ ○ ○ ○
Hold %
○ ○
It will become a measurement display if a pressed.
Refer to P.37 "Mode №b" 「8 step preset output setting」 for a setup of a preset output.
＜Caution＞
1. While registering a preset value (after pressing a until it returns to a setting list),
please do not use the power OFF.
2．A decimal point position is interlocked with the position set up by "Mode №0" when an
output display is "Rate mete."
In "Ratio", it becomes an absolute location of 0.0.
In "Mode №b""a functional stop", it becomes having no decimal point.
Mode
ENT
ENT
RST
ENT
ENT
Mode
ENT
！