UINICS LV1000 Series, Instruction Manual

Page: 28 / 67

- 24 -
2.5V
5V
Analog output value
-1000 0 2000 5000
Rate meter indicated value
【Analog output indication value：№⑨-⑩】
The indicated value when analogue and minimum outputting it and the indicated value at an
analog maximum output are set.
Setting range：-9999 to 9999 <A decimal point is interlocked with the mode No.0>
＜Caution＞
When setting as <analog output minimum indication value ＝ analog maximum output
indication value>, the analog output becomes minimum value.
[Example of setting analog output]
The analog input AV4 (0 to 5V) range. It outputs it synchronizing with the indication.
At indication value (-1000), the output is minimum (OV).
At indication value (5000), the output is maximum (5V).
１ ２ ３ ４ Ａ Ｂ Ｃ Ｄ Ｅ
Analog output minimum indicated value. ○ ○ ○ ● － １ ０ ０ ０ （－１０００）
１ ２ ３ ４ Ａ Ｂ Ｃ Ｄ Ｅ
Analog output maximum indicated value. ○ ○ ○ ◎ ０ ５ ０ ０ ０ （５０００）
Ａ Ｂ Ｃ Ｄ Ｅ
Mode No.A Ａ．０ １ （Rate meter indication）
(It synchronizes with sampling time)
●・・・Light up ○・・・Light disappears
◎・・・Light blinks
The analog output is shown in the figure below. Fig.18
＜Caution＞
１．When the analog output method is set to “Synchronize with the display sampling duration”,
it outputs it by internal sampling duration.
Please set up “synchronization to an indicated value”to output proportion to an
indicated value.
２．Although it is proportional to the set-up slope, if it becomes the minimum exaggerated
value “ -9999 blink”or the maximum exaggerated value “ 9999 blinks”, it will become
0％ or 102.4％ of output compulsorily.
〔Indicated value setup of the output minimum ＜ Indicated value setup of the output maximum〕
“
-9999 blink”・・・・・・・0％ output
“ 9999 blink”・・・・・102.4％ output
〔Indicated value setup of the output minimum ＞ Indicated value setup of the output maximum〕
“
-9999 blink”・・・・・102.4％ output
！
！