UINICS LV1000 Series, Instruction Manual

Page: 51 / 67

- 47 -
１５．How to set the preset value
Set the preset values“OUT1 to OUT4”.
The setting ranges are -9999 to 9999
Setting conditions differ by rate mete or ratio it output.
≪The call method≫
1. It will became「 」display if“ “is pushed 2 sec or more.（Set list）
2. If“ “is pushed, it will become a preset value setup and can perform a setup of OUT1 to
OUT4.
≪The key operation method of the preset value setting≫
Operation key
Display The contents of operation
Ａ Ｂ Ｃ Ｄ Ｅ
９ ９ ９ ９
１ ２ ３ ４
●→○→○→○
Hold %
○ ○
OUT1 to OUT4 setup is switched whenever it presses a
┌→OUT1→OUT2→OUT3→OUT4→┐
└─────────────┘
The lamp corresponding to each preset value of OUT1 to OUT4
lights up at the time of a swithed.
Ａ Ｂ Ｃ Ｄ Ｅ
(-)→
９ →９→９→９
↑ │
└─←───←─┘
１ ２ ３ ４
● ○ ○ ○
Hold %
○ ○
Moves the flash figure when each setting, to the right.
Whenever it pushes once, it moves to the right.
Ａ Ｂ Ｃ Ｄ Ｅ
(-)
９ ９ ９ ９
↑
└０-９
１ ２ ３ ４
● ○ ○ ○
Hold %
○ ○
<Programming displayA>
Ａ Ｂ Ｃ Ｄ Ｅ
(-)
９ ９ ９ ９
↑
└(-),Blank
When pushing. Change the blinkig numeral value.
Every press raises the value by ones.
┌ →０→１→・・・→９→ ┐
└────────────────┘
When pushing. Change the blinking numeral value.
Every press reduces the value by ones.
┌ →９→８→・・・→０→ ┐
└────────────────┘
The display for indication A can be set up (-: minus).
The display range of the display for indication B to D is
0 to 9.
<Programming display A>
It is able to program “-(minus)”indication for display A.
When programming, B – F displays turn on and off.
┌ ⇔ (-) ⇔ Blank ⇔ ┐
└────────────────┘
Mode
Mode
Mode