UINICS LV1000 Series, Instruction Manual

Page: 8 / 67

- 4 -
【Optional specification】
＜Preset output ＋2 step output ：option P4＞
Preset
output
＋
2 step
output
Output terminal Output terminals no.4-5 (OUT3),17-18 (OUT4)
Comparative system Upper limit, lower limit (immediately) and lower limit
(delay). (selectable)
Output mode Comparison, maintenance,(selectable)
Output selection Function stop, Rate mete, Raito,(selectable)
※ Only OUT4 can select the disconnection detection.
Preset value setting The presetting program mode setting is also selectable.
Output judgment
Judgment output is compared with the indication value by
preset value.
Output circuit Tow-row relay 1a output
[ Control capacity / Maximum permissible power ]
AC125V 0.6A （Resistance load）
AC250V 0.3A （Resistance load）
DC 30V 2A （Resistance load）／60W MAX
[ The maximum control current ]
2A MAX
※ Can be used within control current 2A and control
capacity / permissible power.
Output indication
During presetting output, the OUT3 and OUT4 LED are
activated
Hysteresis setting 0-3999 (4 digits to disregard decimal point)
Output reset The key to the pushed for 2 sec or more.
Hysteresis operation
Invalid or selects it from effective.
※ When the output mode is only“Compareson”,it operates.
Preset output state
distinction time It outputs it continuing set time (0.0-99.9 sec) after it
enters the output area at the output area.
＜Preset output ＋8 step output ：option P10＞
Preset
output
＋
8 step
output
Output terminal
D-sub 9 pin connector Output from 2-9（Pin1 is GND）
Comparative system Upper limit, lower limit (immediately) and lower limit
(delay). (selectable)
Output mode Comparison, maintenance,(selectable)
Output selection Function stop, Rate mete, Raito,(selectable)
Preset value setting
The 8 step presetting program mode setting is also
selectable.
Output judgment
Judgment output is compared with the indication value by
preset value.
Output circuit
8 step NPN open collector output
Maximum: DC30V 50mA max
Output reset The key to the pushed for 2 sec or more.
＜ Preset output ＋ 10 step output specification：option P12 ＞
Becames a composition of Preset output ＋ 2 step output ＋ 8 step output
Please refer to the specification of option P4, P10.
／75VA MAX
RST
RST