TriContinent C24000, Product Manual

Page: 139 / 144

Dual pump continuous flow application
C-Series Product Manual
139
After programming has been completed, the AutoRun jumper is
installed on J2. This causes strings to run automatically from EEPROM
on power-up. It also changes the function of the address switch. Its posi-
tion now indicates which EEPROM location contains the string to be run
at power-up.
Note: These are in addition to any other settings that may be required. See
"Set configuration jumpers and address switch" (page 22) for details.
Programming
Overview
The following example provides full stroke continuous flow, in stand-
alone (AutoRun) mode.
• Special command strings are issued to each pump. Because this is a
standalone application, the program strings are loaded into the pumps’
EEPROMs using the [s] command. Strings run automatically at power-up
when the AutoRun jumper is installed on the pumps after programming.
The address switch indicates which string (memory location) will be run.
• Aspirate velocity must be faster than dispense velocity to provide time
for the pump to be ready for triggering after aspiration.
• The [j] command trigger position parameters may require adjustment
based on pump dispense velocity and syringe size.
C3000 example program strings
C3000 Pump A (sent to address 1):
s0J7ZV2000IA3000OV1000j100A0IV2000A3000J7OV1000j100g
H0A0IV2000A3000J7OV1000j100GR
C3000 Pump B (sent to address 2):
s1J7ZV2000IA3000OV1000j100gH0A0IV2000A3000J7OV1000
j100GR
C24000 example program strings
Note: Velocity may need to be scaled to account for the fact that the
C24000 plunger moves 1/4 as fast as the C3000 at the same velocity [V] set-
ting.
Pump A (sent to address 1):
s0J7ZV2000IA24000OV1000j100A0IV2000A24000J7OV1000
j100gH0A0IV2000A24000J7OV1000j100GR
Pump B (sent to address 2):
s1J7ZV2000IA24000OV1000j100gH0A0IV2000A24000J7OV1000
j100G