Toshiba e-studio 2555c, Service Manual

Page: 513 / 1558

6
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2555C/3055C/3555C/4555C/5055C
SETTING / ADJUSTMENT
6 - 87
<Gap to be confirmed>
Fig.6-36
[1] Fuser belt
[2] Pressure roller
[3] Separation guide gap adjustment jig
[4] Separation guide
<Jig to be used>
Separation guide gap adjustment jig
Fig.6-37
<Adjustment procedure>
(1) Insert the 0.6 mm jig into the first window on the fixing plate of the separation guide viewed from
the front, and then adjust the position of the fixing plate of the separation guide.
(2) Adjust it with a screw so that the 0.3 mm jig can be inserted between the separation guide and
the fuser belt, but the 0.8 mm jig cannot.
(3) Insert the jig into the last window on the fixing plate of the separation guide viewed from the front,
and then adjust it in the same manner.
(4) Insert the jig into the remaining three windows on the fixing plate of the separation guide, and
then adjust them in the same manner.
* If the 0.3 mm jig cannot be inserted, the gap is too narrow. Adjust it again.
0.3 - 0.8mm
[1]
[2]
[3]
[4]