Toro Groundsmaster 7210, Service Manual

Page: 290 / 342

Servicing the PTO Driveshaft Cross and Bearing (continued)
Note: Ensure that all the bearing rollers are correctly seated in the
bearing cage.
B. Press 1 bearing partially into the yoke.
IMPORTANT
When installing the cross into the bearing, ensure that you do
not damage the bearing seal.
C. Carefully insert the cross into the bearing and yoke.
D. Hold the cross to align and press the bearing in until it hits the yoke.
E. Carefully position the second bearing into the yoke bore and onto the
cross shaft. Press the bearing into the yoke.
F. Install the 4 snap rings to the bearings to secure the bearings in place.
G. Repeat the procedure for the other yoke.
H. Apply grease to the cross until it comes out of all the 4 bearing cups.
5. Lightly rap the yoke plugs with a soft-faced hammer to remove slight binding.
If the binding continues, disassemble the joint to identify the source of binding.
Note: Ensure that the assembled joint moves without any binding.
6. Install the PTO driveshaft to the machine; refer to Installing the PTO
Driveshaft (page 6–26) .
Chassis: Service and Repairs Page 6–28 Groundsmaster 7210
16222SL Rev C