Toro Groundsmaster 7210, Service Manual

Page: 288 / 342

Removing the PTO Driveshaft (continued)
B. Loosen the 2 bolts and 2 locknuts.
C. Slide the driveshaft end yoke from the gearbox shaft.
D. Remove the PTO driveshaft from the machine.
Installing the PTO Driveshaft
1. Position the PTO driveshaft to the machine.
g033695
Figure 202
1. End yoke 5. Grease fitting
2. Cross and bearing set 6. Yoke and slip tube
3. Grease fitting 7. End yoke
4. Yoke and shaft
Note: Ensure that the driveshaft yoke and slip tube (item 6 in Figure 202 ) is
toward the cutting deck gearbox input shaft.
2. Align the splines and roll pin holes of the driveshaft yokes with the
transmission and gearbox shafts.
3. Slide the PTO driveshaft end yokes onto the transmission PTO shaft and
gearbox shaft.
4. Install the end yokes of the PTO driveshaft as follows:
A. Install the 2 roll pins to the end yokes and shafts.
B. Install the 4 bolts and 4 locknuts that attach the end yokes to the gearbox
shaft and PTO shaft; torque the locknuts to 20 to 25 N∙m (175 to 225
in-lb) .
5. Lubricate the PTO driveshaft grease fittings.
6. Install the fuse F1 (15 A) into the fuse block.
Chassis: Service and Repairs Page 6–26 Groundsmaster 7210
16222SL Rev C