Toro Groundsmaster 7210, Service Manual

Page: 278 / 342

Disassembling the Parking Brake Assembly (continued)
g033686
Figure 193
1. Left cover 2. Bolt (2 each)
2. Remove the 2 bolts (item 2 in Figure 193 ) that attach the left cover to the
machine, and remove the left cover.
3. If necessary, remove the brake handle (item 1 in Figure 192 ) as follows:
A. On both sides of the machine, remove the hairpin cotter and clevis pin
from the brake linkage yoke.
B. Support the brake handle to prevent it from shifting or falling.
C. Remove the 4 screws and 4 nuts that attach the flange bearings to the
frame.
D. Remove the brake handle and flange bearings from the machine.
4. Remove the additional parking brake components as shown in Figure 192 .
Assembling the Parking Brake Assembly
g033687
Figure 194
1. Front brake rod 3. Brake linkage yoke
2. Hex nut
1. Assemble the parking brake components as shown in Figure 192 .
A. If the brake linkage yoke was removed from the front brake rod, install the
yoke onto the rod so that the center-to-center length is 21.1 to 21.2 cm
(8.290 to 8.350 inches) (
Figure 194 ).
B. Ensure that the screws (item 10 in Figure 192 ) that are used to attach
the flange bearings to the frame are installed from the outside of the
frame to the inside.
Chassis: Service and Repairs Page 6–16 Groundsmaster 7210
16222SL Rev C