Toro Groundsmaster 7210, Service Manual

Page: 253 / 342

Removing the PTO Solenoid Valve Coil
1. Park the machine on a level surface, lower the cutting deck (or implement),
set the parking brake, shut off the engine, and remove the key from the
key switch.
2. Raise the operator seat to get access to the PTO solenoid valve coil.
3. Disconnect the wire harness electrical connector from the PTO solenoid
valve coil connector.
4. Remove the nut from the spool assembly.
5. Slide the coil assembly from the solenoid valve stem ( Figure 181 ).
6. Clean any corrosion or dirt from the valve stem.
Installing the PTO Solenoid Valve Coil
1. Slide the new coil assembly, seals, and washers onto the solenoid valve
stem. Ensure that you correctly position the seals and washers ( Figure 181 ).
IMPORTANT
When securing the solenoid valve coil to the solenoid, do not
overtighten the hex nut.
2. Install the hex nut onto the spool assembly and torque the nut to 5.9 to 7.8
N∙m (53 to 69 in-lb) .
3. Connect the wire harness electrical connector to the solenoid valve coil
connector.
4. Lower and secure the operator seat.
Groundsmaster 7210 Page 5–57 Electrical System: Service and Repairs
16222SL Rev C