Toro Groundsmaster 7210, Service Manual

Page: 269 / 342

Removing the Polar Trac Wheels (continued)
g033679
Figure 186
1. Side access cover 2. Locknut and flat washer
2. Loosen, but do not remove the wheel-lug nuts that attach the wheels to the
machine.
3. Position the 2 jack stands under the rear bumper tube at a height so that they
contact or nearly contact the bumper.
4. On the side of the machine that is to have the wheel(s) removed ( Figure 186 ):
A. Remove the 2 screws that attach the side access cover to the machine,
and remove the access cover.
B. Remove the locknut and flat washer that secures the bogie pivot to the
front frame.
5. Position a suitable floor jack under the center of the lift arm pivot tube.
6. Lift the front of the machine with the jack until you support the rear of the
machine on the jack stands and the center tire swings back and nearly
contacts the rear tire. Support the front of the machine with jack stands.
CAUTION
The track guides have many pinch points.
Carefully hold the rubber track on the outer edges outboard of the
steel guides when moving the tracks.
7. Have a second person to lift the center of the track to remove the center
wheel.
8. Remove the 5 wheel-lug nuts that attach the center wheel to the machine,
and carefully remove the center wheel from the track.
9. Once you remove the center wheel, have a second person to lift the track
from other wheel(s) as necessary to remove the additional wheel(s) from
the machine.
Groundsmaster 7210 Page 6–7 Chassis: Service and Repairs
16222SL Rev C