Toro Groundsmaster 7210, Service Manual

Page: 14 / 342

Jacking Instructions
CAUTION
Failing to properly support the machine with appropriate jack stands
can cause the machine to move or fall and can result in personal
injury.
When changing the attachments, tires, or performing other services,
do the following steps:
• Use correct blocks, hoists, and jacks to raise and support the
machine.
• Park the machine on a solid level surface, such as a concrete
floor.
• Before you lift the machine, remove all the attachments that may
interfere with the safe and correct lift of the machine.
• Always block the wheels with chocks.
• Use appropriate jack stands to support the raised machine.
• Do not use the cutting deck (or implement) as a jacking point.
Raising the Front of the Machine
g033384
Figure 2
1. Front castor wheel 2. Front jacking point
1. Set the parking brake and block the 2 rear tires with chocks to prevent the
machine from moving.
2. Position the jack to the machine:
A. On machines with cutting deck, position the jack stands under the square
carrier frame tube near the front castor wheel ( Figure 2 ).
B. On machines with Polar Trac™ Kit, position the jack securely under the
lift arm pivot tube on the front of the machine.
3. Use a jack to raise the front of the machine.
4. After raising the front of the machine, use appropriate jack stands under the
frame to support the front of the machine.
Safety: Jacking Instructions Page 1–6 Groundsmaster 7210
16222SL Rev C