Tonghui Electronics TH7105, Operation Manual

Page: 113 / 187

108
6.4.2.18
Address 19 (End Angle)
1) Commands Description
This command is used to set the end angle in manual mode. The command data range is 0~359. The
command is invalid when the output is turned on.
2) Send Instruction Format
Instrument
address
Function
code
High
address
Low
address
High
bytes
Low
bytes
Number
of data
Data
byte 1
Data
byte 2
CRC
Low
CRC
High
1~32 0x10 0x00 0x13 0x00 0x01 0x02
0~359
High
8-bit
0~359
low
8-bit
Calculated based
on the first 9 bytes
3) Return Instruction Format
6.4.2.19
Address 20 (Measurement Result)
1) Commands Description
This command is used to set the result display mode in manual mode. The command is invalid when the
output is turned on. The instruction data byte bit corresponds to the function of the instrument as shown
in below table:
Data Byte Result Display Mode
0x00 This command is used to set the result display mode to NONE in manual mode.
0x01 This command is used to set the result display mode to LAST in manual mode.
0x02 This command is used to set the result display mode to ALL in manual mode.
0x03 This command is used to set the result display mode to P/F in manual mode.
2) Send Instruction Format
Instrument
address
Function
code
High
address
Low
address
High
bytes
Low
bytes
Number
of data
Data
byte 1
Data byte 2
CRC
Low
CRC
High
1~32 0x10 0x00 0x14 0x00 0x01 0x02 0x00
0x00 or 0x01 or
0x02 or 0x03
Calculated
based on the
first 9 bytes
3) Return Instruction Format
Instrument
address
Function
Code
High Address Low Address High bytes Low bytes CRC Low CRC High
1~32 0x10 0x00 0x13 0x00 0x01
Calculated based on the first 6
bytes
Instrument
address
Function
Code
High Address Low Address High bytes Low bytes CRC Low CRC High