Tonghui Electronics TH7105, Operation Manual

Page: 186 / 187

181
47 2 Read/Write 0.1~999.9
Set or query the ramp down time of the current step in
the programmed mode
48 2 Read/Write 0~300
Set or query the voltage of the surge drop in the
programmed mode
49 1 Read/Write 0~99or0~20
Set or query the position where the surge drop appears in
the programmed mode.
50 1 Read/Write 0~99or0~20
Set or query the time width of the surge drop in the
programmed mode
51 1 Read/Write
0
Set or query the SD connection status of the surge drop in
the programmed mode. 0 means the SD connection is off;
1 means the SD connection is on.
1
52 2 Read/Write 0~300
Set or query the high limit of the voltage in the
programmed mode
53 2 Read/Write 0~300
Set or query the low limit of the voltage in the
programmed mode
54 2 Read/Write 45~500
Set or query the high limit of the frequency in the
programmed mode
55 2 Read/Write 45~500
Set or query the low limit of the frequency in the
programmed mode
56 1 Read/Write 0~359 Set or query the staring angle in the programmed mode
57 1 Read/Write 0~359 Set or query the end angle in the programmed mode
58 1 Read/Write
0 Set or query the result display mode in the programmed
mode. 0 means the result display mode is LAST in the
programmed mode; 1 means the result display mode is
ALL in the programmed mode; 2 means the result display
mode is P/F in the programmed mode.
1
2
59 1 Read/Write
0
Set or query the state of the surge drop in the
programmed mode. 0 means that the surge drop is in the
off state; 1 means that the surge drop is on
1
60 1 Read/Write
0
Set or query the state of over current fold in the
programmed mode. 0 means that the over current fold is
in the off state; 1 means that the over current fold is in the
on state
1
61 1 Read/Write 0~999
Set or query the loop cycle of the memory sequence in the
programmed mode
62 1 Read/Write
0
Set or query the status of the single-step test in the
programmed mode. 0 means single step test is off; 1
means single step test is on
1
63 1 Write The instruction is used to exit the result display state