Timewave DSP-232, Operating Manual

Page: 195 / 271

Chapter 10 Morse Operation
n 0 to 21 signifies a modem number from the list below.
The MODEM command determines what DSP Modem is selected for the DSP-232. The Modems available in
EPROM are listed below.
The DSP modems included in the DSP-232 can be shown with the DIRECT(ory) command and are listed below.
1: FSK 45 bps 2125/2295
2: FSK 100 bps 2125/2295
3: FSK 45 bps 1615/1785
4: FSK 100 bps 1615/1785
5: FSK 200 bps 2110/2310
6: FSK 200 bps 1600/1800
7: FSK 200 bps 2125/2550
8: FSK 200 bps 1275/1700
9: FSK 200 bps 2125/2975
10: FSK 200 bps 1275/2125
11: FSK 300 bps 2110/2310
12: FSK 300 bps 1600/1800
13: FSK
1200 bps VHF
14: PACSAT 1200 bps BPSK
15:
16: FSK
9600 bps K9NG/G3RUH
17: Analog FAX HF 1450/2500 FM
18: Analog FAX APT 2400 Hz AM
19: Zero-Crossing FAX 1300/2100
20: Morse 750 Hz.
21: OSCAR-13 Telemetry 400 bps BPSK
cmd:
MOPtt ON|OFF
Default: ON
Mode: Morse Host: Mo
ON Enables PTT in Morse transmit mode.
OFF Disables PTT in Morse transmit mode.
MOPTT
controls the PTT output in Morse mode only. To enable PTT for Morse transmissions, both
XMITOK
and
MOPTT
must be
ON
.
XMITOK OFF
still disables PTT for all operating modes.
The most probable use of
MOPTT
is to disable PTT in Morse to allow full break-in operation but enable PTT in all
the other modes. Setting XMITOK ON and MOPTT OFF accomplishes this.
MOPTT doesn’t affect the Morse IDs generated by MID (in Packet mode) and by the CWID character (in other
digital operating modes);
ATXRTTY
may also be helpful.
MOrse Immediate Command
Mode: Command Host: MO
MORSE
switches your DSP into the Morse mode.
Unless you change
MSPEED
, your DSP uses the default Morse transmit speed value of 20 WPM.
MSPeed n Default: 20 wpm
Mode: Morse Host: MP
“
n ” 5 to 99 signifies your DSPs Morse transmit speed.
September, 05 10-9