Timewave DSP-232, Operating Manual

Page: 182 / 271

Chapter 9 AMTOR Operation
RXREV operates only at RBAUD and ABAUD speeds up to 150 baud.
SELfec aaaa [ aaa ]
Immediate Command
Mode: AMTOR FEC Host: SE
aaaa Specifies the distant station’s SELCALL .
SELFEC starts a SELective FEC (mode Bs) transmission to a specific station when you enter that station’s
SELCALL
(SELective CALLing) code. The
SELFEC
command must be accompanied by a unique character
sequence (
aaaa
) that contains 4 or 7 alphabetic characters. You don’t have to type the
SELCALL
a second time if
you intend to call the same station again right away.
See
MYSELCAL and MYIDENT to enter your 4- and 7-character SELCALL s.
SRXall ON | OFF Default: OFF
Mode: AMTOR Host: SR
OFF
Receive only
SELCALL
-addressed
SELFEC
transmissions.
ON
Receive all
SELFEC
transmissions.
SRXALL
permits the reception of selectively coded inverse FEC signals normally not available for decoding. Set
SRXALL ON to activate this feature.
TMail ON | OFF Default: OFF
Mode: AMTOR and PACTOR Host: TL
OFF The DSP only operates as a normal AMTOR CCIR 476 or 625 or PACTOR controller.
ON
The DSP operates as a personal AMTOR or PACTOR BBS or Maildrop.
The DSPs Maildrop is a personal mailbox that uses a subset of the W0RLI/WA7MBL PBBS commands and is
similar to operation of APLINK stations. Turn
TMAIL ON to allow other stations to access your Maildrop in ARQ
PACTOR; third-party messages aren’t accepted by your AMTOR or PACTOR Maildrop unless
3RDPARTY
is
ON .
TMPrompt text
Default: (see text)
Mode: AMTOR/Maildrop Host: Tp
text Any combination of characters and spaces up to a maximum of 80 bytes.
TMPROMPT is the command line sent to a calling station by your AMTOR Maildrop in response to a Send
message command. The default text is:
GA subj/GA msg
,
’/EX’ to end.
Text before the first slash is sent to the user as the subject prompt; text after the slash is sent as the message text
prompt.
September, 05 9-23