Timewave DSP-232, Operating Manual, Page: 11 / 271

Chapter 1 The DSP-232
‘F’ lights when you’re in FEC mode in AMTOR or PACTOR.
‘A’ comes on when you’re in ARQ mode in AMTOR.
‘L’ comes on when you’re in Listen mode in AMTOR or PACTOR
‘t’ comes on when sending “traffic” in AMTOR.
‘E’ This stands for ERROR. When not in packet, it’ll glow when it has trouble receiving—
or when it has received—a bad “block” of data while in PACTOR or AMTOR .
‘P’ Stands for PHASE and indicates that while in AMTOR or PACTOR, your transmitter is
trying to lock onto and synchronize with another station’s signal.
‘S’ Stands for SELFEC and will glow when you’re operating SELFEC AMTOR.
‘I’ IDLE is next. When on—while in AMTOR or PACTOR—it indicates that although
you’re connected to another station, no traffic is being transmitted or received.
‘r’ comes on when an error has occurred and the DSP ‘Requests’ a re-transmission.
‘o’ Stands for OVER and lights up when the DSP goes from transmit to receive while in
AMTOR or PACTOR.
Other Indicators
September, 05 1-5