Timewave DSP-232, Operating Manual

Page: 24 / 271

Chapter 2 Power Supply and Computer Installation
18. Now, at the cmd:, type:
EXPERT ON
Press (RETURN) and then type:
UBIT 0 OFF
19. Enter the following text after the
cmd:
prompt to set your test callsign to AAA :
MYCALL AAA
After you’ve entered this, the DSP will print the following on the screen:
MYcall was DSP232
MYcall now AAA
20. Enter the following command to “connect” to
AAA
: (the DSP-232 recognizes the letter C to mean “connect
to...”)
C AAA
After a few moments, your monitor should display:
*** CONNECTED to AAA
21. Type Hi, there! , then press ( RETURN ). Your monitor should echo the same message.
22. Now you’ll exit out of the packet mode. The following command will force the DSP to “disconnect” from
a station and exit the packet mode:
(
CTRL-C
)
cmd:
D
If you’ve gotten this far, then the DSP and its Radio Port 2 9600 bps VHF packet modem is working properly.
If you still have problems after consulting
Chapter 13 - Troubleshooting , leave your DSP on and call AEA’s
Technical Support department at (206) 775-7373. If all tests went well, your DSP’s modems and Radio Ports are
functioning properly. Any problems that arise from this point on will most likely stem from cabling or radio
problems. Now, move on to
Chapter 3 Radio Installation .
September, 05 2-11