Teledyne CombiFlash EZ Prep, User Manual

Page: 92 / 245

Section 4 Preparation: Optional 4x Module
4-7
Note
If the waste is to be collected in a common container, skip the
Column Waste and Waste Level Sense connections (steps 1
through 7) and complete step 8 to route the Valve Waste Out from
the Rf 4x module to the common container. The waste tubing
assembly connected to the back panel of the Combi
Flash Rf
system will route all waste fluids to the common collection
container and sense the level.
To complete the waste line connections:
1. At the waste container for the Combi Flash Rf system
(Channel 1), remove the black tubing that delivers Diverter
Valve Waste fluid and the natural tubing that delivers
Waste Level Sense air. The cap and black tubing from the
Inject Valve Waste should remain attached to the waste
bottle.
2. At the Combi Flash Rf system back panel, disconnect the
black tubing from the Diverter Valve Waste port and the
natural tubing from the Waste Level Sense port.
Note
The Inject Valve Waste tubing must remain connected between
the Rf system back panel and its waste container.
Refer to Figures 4-5 and 4-6 for steps 3 and 4.
3. Locate the 20 inch (50 cm) long Column Waste Assembly
(P/N 60-5234-192) in accessory package 60-5239-008.
Connect this tubing between the Combi
Flash Rf system
and the Rf 4x module:
a. Connect the cut end of the black tubing to the
Combi Flash Rf system Diverter Valve Waste port. Use a
black nut and ferrule from the accessory package.
Finger-tighten the nut to seat the ferrule in the
bulkhead fitting.
Fe
rr
u
le
Nut
T
ubing