Teledyne CombiFlash EZ Prep, User Manual

Page: 68 / 245

Section 3 Preparation: Rf 150 Systems
3-3
3.2 Instrument Location
The Combi Flash Rf 150 has a relatively small footprint,
requiring about 1550 square centimeters (240 in
2
) of level
bench space. Ensure that the Combi Flash Rf has at least 3 cm
(1.25") of air space behind it for ventilation. Additional space
may be required for solvent and waste containers.
Refer to Table 1-1 of this guide for environmental conditions
and power requirements.
WARNING
The system is heavy. Use a two-person lift to prevent injury.
Before making any connections to the Combi Flash Rf 150,
place the system on the bench or in the fume hood where it
will be operated. Temporarily position the system so you can
access the back panels to complete the connections.
3.3 Connect Power
Ensure that the On/Standby switch below the touch screen
panel is in the Standby position. Then, use the supplied IEC
power cord to connect the Combi
Flash Rf to mains power.
WARNING
Mains power must meet the voltage, frequency, and amperage
requirements listed on the serial number label.
WARNING
As long as the AC mains power cord is connected, power is
inside the unit. The mains power cord is the disconnect device.
Position the Rf 150 system so that the power cord can be
unplugged, or use a power strip where the plug can quickly be
removed from the outlet in the event of an emergency.