Teledyne CombiFlash EZ Prep, User Manual

Page: 95 / 245

CombiFlash® Rf
+
User Manual
4-10
5. Select one of the four waste line assemblies (PN
60-5234-188) from the accessory package. This will be used
to complete the waste connections for channel 1 as shown
in Figure 4-8.
Note
These instructions assume that the column waste from each
channel will be isolated in separate containers. If the waste is to be
collected in a common container, omit the use of the waste caps
and secure all liquid and air lines in the common container. The
ends of all air lines should extend at least 2 inches (5 cm) below
the container opening.
a. At the Rf 4x back panel, connect the threaded fitting on
the waste line assembly to the Column Waste port
labeled “1.”
b. At the Rf 4x back panel, connect the natural tubing of
the waste line assembly to the Waste Level Sense port
labeled “1.”
c. At the Combi Flash Rf system back panel, the black
tubing should still be connected to the Inject Valve
Waste port (from step 1). If not, reconnect the tubing.
d. At the waste container cap for channel 1, insert the
black tubing into the Diverter Valve Waste opening.
e. At the waste container cap for channel 1, insert the
natural tubing into the Waste Level Sense opening
(Figure 4-7). Push the stop (ferrule) on the Waste Level
Sense tubing against the cap. This ensures that the
Waste Level Sense tubing is far enough into the
container to detect when it is nearly full.
f. At the waste container cap for channel 1, insert the
black tubing from the Inject Valve Waste port. The
completed waste connections for Channel 1 are shown in
Figure 4-8.
6. Using one of the three remaining waste line assemblies
and waste caps, complete the waste connections for channel
2 as shown in Figure 4-9.
7. Using the three remaining waste line assemblies and waste
bottle caps, complete the waste connections for channels 2
through 4 as shown in Figure 4-9.