14
www.teejet.com
Aeros 9040 field computer
HOME
GUID
ANCE
FULL SCREEN
IMPLEMENT
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
SE
TUP
►Applied alert – used to establish an alert to signal when
exiting or entering an applied area
►BoomPilot start mode – used to establish whether BoomPilot
will be controlled by speed or by the BoomPilot icon
►BoomPilot icon – used to activate the guidance screen icon
for manually controlling on-screen application painting
4. Press NEXT PAGE arrow to set up specific implement
options. See the Implement chapter for details.
5. Press RETURN arrow
or CONFIGURATION side tab
to
return to the main Configuration screen.
Figure 4-6: Implement
–
Single section setup
Section(s) with ISOBUS sprayer/spreader setup
Some Implement options are completed on the ISOBUS ECU. When
these options are also available in the Implement setup section, they
will be greyed out or unavailable.
1. Press CONFIGURATION side tab
.
2. Press
Implement
.
3. Select from:
►Machine type [when available] – used to select the type of
machine that most closely represents your machine
►GNSS antenna height [when available] – used to measure the
height of the antenna from the ground
►Implement type – used to select the layout of the sections for
the applied product location
►Application width [Straight implement type completed on
ISOBUS ECU] – used to display the total width of the
implement as entered on the ISOBUS sprayer
►Working width [Spreader implement type completed on
the ISOBUS ECU] – used to display the total width of the
implement as entered on the ISOBUS spreader
►Droplet size monitor [available only with Pressure sensor
interface kit] – used to enable droplet size monitoring for up to
five sprayer tips
►Nozzle selection [Straight implement type completed on the
ISOBUS ECU] – used to display the type of sprayer nozzle as
entered on the ISOBUS sprayer
►Applied alert – [only available without a switchbox] used to
establish an alert to signal when exiting or entering an applied
area
►BoomPilot start mode – used to control BoomPilot
automatically by speed, or manually by BoomPilot icon
►BoomPilot icon – used to activate icon for manually controlling
BoomPilot
4. Press NEXT PAGE arrow to set up specific implement
options. See the Implement chapter for details.
5. Press RETURN arrow
or CONFIGURATION side tab
to
return to the main Configuration screen.
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
