20
www.teejet.com
Aeros 9040 field computer
HOME
GUID
ANCE
FULL SCREEN
IMPLEMENT
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
SE
TUP
GNSS
GNSS is used to configure GNSS type, GNSS port, and PRN, as
well as to view GNSS status information.
NOTE: For more information, see the GNSS chapter of this manual.
These settings are required for assisted/auto steering, tilt
sensor operation, and rate control functionality, as well as
proper implement operation.
1. Press CONFIGURATION side tab
.
2. Press
GNSS receiver configuration
.
3. Select from:
►GNSS type – sets to accept GNSS source transmissions:
GPS, GLONASS, SBAS (with or without DGPS required)
►GNSS port – sets GNSS communication port to either internal
or external
►GNSS status information – displays current GNSS status
information
►Program – only TeeJet support technicians should use this
feature
►PRN – selects the first of two possible SBAS PRN's to provide
SBAS correction data. Set to
Automatic
for automatic PRN
selection.
►Alternate PRN – when PRN is not automatic, allows possible
selection of a second SBAS PRN to provide correction data
►Show refresh GNSS position button – establishes if the
refresh GNSS position button is available on the guidance
screens.
NOTE: Activating the refresh while in a job will cause a
momentary interruption in the relay of GNSS data. This
will most likely result in sections already on in automatic
BoomPilot mode to go off for a short period of time.
The refresh should not be done during active application.
4. Press NEXT PAGE arrow to set up the selected specific
GNSS options.
5. Press RETURN arrow
or CONFIGURATION side tab
to
return to the main Configuration screen.
Figure 4-16: GNSS options
PRN not shown
PRN options are only available with SBAS GNSS type selected.
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
