27
98-05304-EN R2
Aeros 9040 field computer
HOME
GUID
ANCE
FULL SCREEN
IMPLEMENT
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
SE
TUP
Tilt correction
When a Steering control module (SCM) or Tilt gyro module (TGM) is
present, Tilt correction is available. This corrects the GNSS signal to
compensate for errors in the GNSS position while operating on hilly
or sloped terrain.
For detailed setup instructions, refer to your specific assisted/auto
steering installation manual or tilt setup bulletin.
1. Press CONFIGURATION side tab
.
2. Press
Tilt correction
.
3. Select if Tilt correction is enabled or disabled.
4. When enabled, select
Field level
to calibrate tilt correction.
5. Press RETURN arrow
or CONFIGURATION side tab
to
return to the main Configuration screen.
NOTE: If FieldPilot or UniPilot is being used, a Tilt gyro module
is built into the system. When using a FieldPilot Pro or
UniPilot Pro, tilt correction is calibrated under Setup->
Configuration-> AutoSteer-> Manage vehicles-> Adjust-> Tilt
calibration.
NOTE: Antenna height must be entered prior to tilt calibration.
Figure 4-28: Tilt Correction
Field level unavailable
If the vehicle is in motion, the field level option will not be available.
Vehicle must be stopped for at least 10 seconds to begin to calibrate
tilt correction.
Tilt correction unavailable
If an SCM or TGM is not connected, setup options will not be
available. When using a FieldPilot Pro or UniPilot Pro, tilt correction
is calibrated under Setup-> Configuration-> AutoSteer-> Manage
vehicles-> Adjust-> Tilt calibration.
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
