TeeJet Technologies AEROS 9040, User Manual

Page: 62 / 126

54
www.teejet.com
Aeros 9040 field computer
HOME
SE
TUP
GUID
ANCE
FULL SCREEN
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
IMPLEMENT
Spreader – OEM
A virtual line is created in line with the delivery disks from which
the application section or sections can vary in length and can be at
different distances from the line.
Single section
No section control is available on the system.
1. Select
Spreader
implement type on Implement screen.
2. Press Implement type NEXT PAGE arrow .
3. Select from:
►Setup type – used to select
OEM
spreader type
►Antenna to disks in-line offset distance – measured in parallel
to the centreline of the machine, defines the in-line distance
from the GNSS antenna to the disks, or dispersal mechanism
►Implement lateral offset direction – defines the lateral
direction, either left or right, from the centreline of the machine
to the centre of the implement while facing in the machine's
forward direction
►Implement lateral offset distance – defines the lateral distance
from the centreline of the machine to the centre of the
implement
►Start distance – used to set the start distance when exiting an
applied area (consult spreader manufacturer for value)
►Stop distance – used to set the stop distance when entering
an applied area (consult spreader manufacturer for value)
NOTE: Consult spreader manufacturer for start and stop
distances.
4. Press RETURN arrow to return to the Implement screen
or CONFIGURATION side tab to return to the main
Configuration screen.
Figure 6-21: Single section
Multiple sections
Section control is available (SmartCable, Section driver module
(SDM), or Switch function module (SFM) or ISOBUS).
1. Select
Spreader
implement type on Implement screen.
2. Press Implement type NEXT PAGE arrow .
3. Select from:
►Setup type – used to select
OEM
spreader type
►Antenna to disks in-line offset distance – measured in parallel
to the centreline of the machine, defines the in-line distance
from the GNSS antenna to the disks, or dispersal mechanism
►Implement lateral offset direction – defines the lateral
direction, either left or right, from the centreline of the machine
to the centre of the implement while facing in the machine's
forward direction
►Implement lateral offset distance – defines the lateral distance
from the centreline of the machine to the centre of the
implement
►Start distance – used to set the start distance when exiting an
applied area (consult spreader manufacturer for value)
►Stop distance – used to set the stop distance when entering
an applied area (consult spreader manufacturer for value)
NOTE: Consult spreader manufacturer for start and stop
distances.
►Section start offsets – used to set the offset distance from
section 1 to the leading edge of each section. Section 1 is
always 0. All other sections can be different distances.