TeeJet Technologies AEROS 9040, User Manual

Page: 115 / 126

107
98-05304-EN R2
Aeros 9040 field computer
HOME
SE
TUP
GUID
ANCE
FULL SCREEN
IMPLEMENT
INTR
ODUC
TION
GNSS
APPENDIX
RA
TE C
ONTR
OL
Target rate map
Target rate map shows the target application rate that the rate
controller attempted to achieve at each location.
NOTE: Application map and Target rate map cannot be selected
simultaneously.
On screen mapping
• Coverage area – illustrates applied area:
◄ User selected – applied areas show colored bars relative to
selected colour range and map selection.
Figure 8-14: Target rate map
27.00
ha
10.0
km/h
Mark A
Target rates
Preset target application rates define target rates of product being
applied per hectare/acre. These settings will set the same for all
active jobs.
Target rates are established on the ISOBUS ECU using the
ISOBUS UT. The current Target rate is selected and boosted using
the ISOBUS Operation screen on the UT. Boosting can also be
controlled using the Vehicle view screen
• Up to five (5) target rates can be established
Colour range selection
Product options configure maximum/minimum rate limits and
corresponding display colours for mapping.
1. Press SYSTEM SETUP bottom tab
.
2. Press CONFIGURATION side tab .
3. Press
Product
.
4. Select:
►Color range – mode used to set the rate for Maximum rate
colour and Minimum rate colour.
◄ Automatic – maximum and minimum will be determined by
actual applied rate values or target rate values
◄ Manual – maximum and minimum limits will be set to those
set in Applied rate mapping upper limit and Applied rate
mapping lower limit options
►Maximum rate colour – used to set the colour for the
maximum rate. When in Manual colour range mode, this
colour will be used for all rates above the Applied Rate
mapping upper limit
►Minimum rate colour – used to set the colour for the minimum
rate. When in Manual colour range mode, this colour will be
used for all rates below the Applied rate mapping lower limit
Figure 8-15: Product options