55
98-05304-EN R2
Aeros 9040 field computer
HOME
SE
TUP
GUID
ANCE
FULL SCREEN
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
IMPLEMENT
►Section stop offsets – used to set the offset distance from
section 1 to the trailing edge of each section. Each section
can be a different distance.
NOTE: Consult spreader manufacturer for section start and
stop offset values. Sections are numbered from left to right
while facing in the machine's forward direction.
4. Press RETURN arrow
to return to the Implement screen
or CONFIGURATION side tab
to return to the main
Configuration screen.
Figure 6-22: Multiple sections
Staggered
A virtual line is created in line with section 1 from which the
application section or sections have no length and can be at different
distances from the line.
Multiple sections
Section control is available (SmartCable, Section driver module
(SDM), or Switch function module (SFM) or ISOBUS).
1. Select
Staggered
implement type on Implement screen.
2. Press Implement type NEXT PAGE arrow
.
3. Select from:
►Section 1 in-line offset direction
– establishes if Section
1 (the zero-point of the Section Offsets) is located in front
of (forward) or behind (backward) the GNSS antenna while
facing in the machine's forward direction
►Section 1 in-line offset distance
– measured in parallel to
the centreline of the machine, defines the in-line distance from
the GNSS antenna to Section 1 (the zero-point of the Section
Offsets). Sections are numbered from left to right while facing
in the machine's forward direction
►Implement lateral offset direction
– defines the lateral
direction, either left or right, from the centreline of the machine
to the centre of the implement while facing in the machine's
forward direction.
►Implement lateral offset distance
– defines the lateral
distance from the centreline of the machine to the centre of
the implement
►Overlap – used to define the amount of overlap allowed when
using automatic boom section control
►Delay on time – used to set the time when the section will
switch on when entering an area that has not been applied
NOTE: If the application turns on too soon when entering
an unapplied area, decrease the Delay on time. If the
application turns on too late, increase the Delay on time.
►Delay off time – used to set the time when the section will
switch off when entering an area that has been applied
NOTE: If the application turns off too soon when entering
an unapplied area, decrease the Delay off time. If the
application turns off too late, increase the Delay off time.
►Section offsets
– used to set the offset distance from
section 1 (the In-line section 1 offset distance line) to each
section. A positive offset value will move the section behind
section 1. A negative offset value will move the section in front
of section 1. Section 1 is always 0. All other sections can be
different distances.
4. Press RETURN arrow
to return to the Implement screen
or CONFIGURATION side tab
to return to the main
Configuration screen.
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
