62
www.teejet.com
Aeros 9040 field computer
HOME
SE
TUP
GUID
ANCE
FULL SCREEN
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
IMPLEMENT
IMPLEMENT LATERAL OFFSET DISTANCE ADJUSTMENT
Implement lateral offset distance is used to enter the distance from
the centreline of the machine to the centre of the implement. When
on-screen mapping shows no overlap or gap, yet field application
produces an overlap or gap consistently to only one side in the
direction of travel, an adjustment to the Implement lateral offset
distance should be calculated and made to the implement offset
distance value.
If using a self-propelled sprayer or spreader, use the GNSS offset
adjustment calculation to calculate the implement lateral offset
distance adjustment.
If using a pull behind or trailed implement, use the Implement offset
adjustment calculation to calculate the implement lateral offset
distance adjustment.
NOTE: While using assisted/auto steering, if on-screen mapping
shows overlaps and gaps, adjustments may need to be made
to the assisted/auto steering settings.
Figure 6-35: Implement lateral offset distance
GNSS offset adjustment calculation
To calculate a GNSS offset adjustment using the same guideline:
1. Create a straight AB line.
2. With assisted/auto steering engaged, drive pass
at least 100 feet / 30 meters, and place flags at the draw bar or next to the machine.
3. Turn around and engage assisted/auto steering on pass
on the same AB guideline. Place flags at the draw bar or next to the machine,
or stop while on the AB guideline next to the flags you placed on pass
.
4. Measure the difference
between the flags of pass
and pass
.
5. Divide the measured distance
in half. This difference will be the offset adjustment.
6. Increase or decrease the offset distance as needed dependent on where the field application overlap occurs and the current implement
offset direction setting.
Field application overlap
Current offset settings
Offset direction = left
Offset direction = right
Offset direction = right
offset distance = 0 ft/m
To the right of pass
Increase distance offset value
Decrease distance offset value
Increase distance offset value
To the left of pass
Decrease distance offset value
Increase distance offset value
Change to implement offset direction to
left and increase distance offset value
Figure 6-36: GNSS Offset Distance
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
