57
98-05304-EN R2
Aeros 9040 field computer
HOME
SE
TUP
GUID
ANCE
FULL SCREEN
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
IMPLEMENT
APPLICATION OR WORKING WIDTH
Application width [Straight implement type or Staggered implement type] or Working width [Spreader implement type] is used to enter the
width of the single section or width of each section to calculate the total width of the implement.
Single section
No section control is available on the system.
Application width or Working width is used to enter the total width of
the single section of the implement. Range is 1.0 to 75.0 metres.
1. Press CONFIGURATION side tab
.
2. Press
Implement
.
3. Press the Application width [Straight implement type] or Working
width [Spreader implement type] KEYPAD icon
.
4. Use the numeric keypad to enter a value.
5. Press RETURN arrow
or CONFIGURATION side tab
to
return to the main Configuration screen.
Figure 6-27: Single section – Application or Working width
Multiple sections
Section control is available when any of the following are on the
system: SmartCable, Section driver module (SDM), Switch function
module (SFM) or compatible ISOBUS Implement ECU.
Application width or Working width is used to enter the width of each
section to calculate the total width of all sections of the implement.
Each section can be a different width. Sections are numbered from
left to right while facing in the machine's forward direction. Range
for each section is 0.0 to 75.0 metres. Total for all sections must be
greater than 1.0 metre.
1. Press CONFIGURATION side tab
.
2. Press
Implement
.
3. Press the Application width [Straight implement type or
Staggered implement type] or Working width [Spreader
implement type] KEYPAD icon
.
4. Highlight the section to be entered or edited.
5. Press the KEYPAD icon
.
6. Use the numeric keypad to enter the width of the selected
section.
7. Press RETURN arrow
or CONFIGURATION side tab
to
return to the Implement screen or main Configuration screen.
NOTE: If Symmetric implement layout is enabled, only the first
of each pair of aligned sections will be available to be
highlighted.
Figure 6-28: Multiple sections
–
Application or Working width
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
