41
98-05304-EN R2
Aeros 9040 field computer
HOME
SE
TUP
GUID
ANCE
FULL SCREEN
IMPLEMENT
INTR
ODUC
TION
RA
TE C
ONTR
OL
APPENDIX
GNSS
CHAPTER 5 – GNSS RECEIVER CONFIGURATION
GNSS Receiver Configuration is used to configure GNSS type, GNSS port, and PRN, and other GNSS parameters, and to view GNSS status
information.
GNSS
NOTE: These settings are required for rate control, assisted/
auto steering, and tilt sensor operation, as well as proper
implement operation.
1. Press CONFIGURATION side tab
.
2. Press
GNSS receiver configuration
.
3. Select from:
►GNSS type – sets to accept GNSS source transmissions:
GPS, GLONASS, or SBAS (with or without DGPS required).
►GNSS port – sets GNSS communication port: Internal or
External
►GNSS status information – displays current baud rate, baud
rate status, GNSS status information: GGA/VTG (data rates),
number of satellites, HDOP, PRN, GGA quality, receiver,
receiver version, UTM zone, and correction model
►Programme – allows direct programming of the GNSS receiver
through a command line interface. Only TeeJet support
technicians should use this feature. Use at your own risk!
►PRN – selects the first of two possible SBAS PRN's to provide
SBAS correction data. Set to
Automatic
for automatic PRN
selection.
►Alternate PRN – when PRN is not automatic, allows possible
selection of a second SBAS PRN to provide correction data
►Show refresh GNSS position button – establishes if the refresh
GNSS position button is available on the guidance screens.
4. Press RETURN arrow
or CONFIGURATION side tab
to
return to the main Configuration screen.
Figure 5-1: GNSS options
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
