91
98-05304-EN R2
Aeros 9040 field computer
HOME
SE
TUP
FULL SCREEN
IMPLEMENT
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
GUID
ANCE
REFRESH GNSS POSITION
Refresh GNSS position resets the ClearPath filter in the OEMStar
receiver in cases where the user has had the receiver running
in close proximity to heavy tree cover and/or buildings. See
“Configuration-> GNSS receiver configuration” to activate the
Refresh GNSS poisition icon.
NOTE: Activating the refresh while in a job will cause a momentary
interruption in the relay of GNSS data. This will most likely
result in sections already on in automatic BoomPilot mode to
go off for a short period of time.
The refresh should not be done during active application.
To refresh the GNSS position:
1. Press NAVIGATION AND GUIDANCE OPTIONS tab
to
display navigation options.
2. Select Refresh GNSS POSITION icon
.
Figure 7-33: Refresh GNSS position
15:22
0.0
km/h
NOZZLE FAULT RESET
Nozzle fault reset clears any nozzle fault indications. See
“Configuration-> Nozzle flow monitor” to adjust alarm configurations.
To reset the nozzle fault indications:
1. Press NAVIGATION AND GUIDANCE OPTIONS tab
to
display navigation options.
2. Select NOZZLE FAULT RESET icon
.
Figure 7-34: Nozzle Flow Monitor
13:12
7.2
km/h
Mark A
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
