88
www.teejet.com
Aeros 9040 field computer
HOME
SE
TUP
FULL SCREEN
IMPLEMENT
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
GUID
ANCE
ISOBUS sprayer
If an ISOBUS electronic control unit (ECU) is present, the
BoomPilot icon or an optional switchbox can be used to turn
the boom on or off. The BoomPilot icon may also be used to set
automatic section control to manual or automatic . The
number of section widths displayed will depend on the ISOBUS ECU
configuration.
NOTE: The BOOMPILOT icon is grey
when GNSS is
unavailable.
Console and ECU only
All ISOBUS rate control configurations should be setup before
starting BoomPilot. Automatic or manual regulation mode should not
affect the following options.
To set configuration settings:
1. Press SYSTEM SETUP bottom tab
.
2. Press CONFIGURATION side tab
.
3. Press
Implement
.
4. Set “BoomPilot icon” to
Enable
.
NOTE: BoomPilot start mode setting will make no difference in the
function of this option.
To switch application off or on automatically:
1. Press NAVIGATION AND GUIDANCE OPTIONS tab
to
display navigation options.
2. Press BOOMPILOT icon .
◄Automatic – status bar icon will change to green
NOTE: Application can be manually controlled while in Automatic
BoomPilot mode using the Start/stop key on the ISOBUS
Operation screen.
To switch application off or on manually:
1. Press NAVIGATION AND GUIDANCE OPTIONS tab
to
display navigation options.
2. Press BOOMPILOT icon .
◄Automatic – status bar icon will change to red
3. Press ISOBUS UNIVERSAL TERMINAL bottom tab
.
4. Go to the Operation screen
5. Use the START/STOP key .
With switchbox
All ISOBUS rate control configurations should be setup before
starting BoomPilot. Automatic or manual regulation mode should not
affect the following options.
To set configuration settings:
1. Press SYSTEM SETUP bottom tab
.
2. Press CONFIGURATION side tab
.
3. Press
Implement
.
4. Set “BoomPilot icon” to
Disable
.
NOTE: BoomPilot start mode setting will make no difference in the
function of this option.
To switch application off or on automatically:
1. Switchbox master switch and section switches must be in the
“On” positions.
1. Press NAVIGATION AND GUIDANCE OPTIONS tab
to
display navigation options.
2. Press BOOMPILOT icon .
◄Automatic – status bar icon will change to green
NOTE: Application can be manually controlled while in Automatic
BoomPilot mode using the master switch or individual
section switches.
Caution: With some versions of ISOBUS software, while in a
previously applied area, manually changing a section switch
will change BoomPilot to manual mode. Therefore, if a switch
remained in the on position after exiting the applied area, it
would remain off.
To switch application off or on manually:
1. Press NAVIGATION AND GUIDANCE OPTIONS tab
to
display navigation options.
2. Press BOOMPILOT icon .
◄Manual – status bar icon will change to red
3. Turn master switch or individual section switches On/Off.
Summary of Contents for AEROS 9040
Page 1: ...Software version 4 31 U S E R M A N U A L AEROS 9040...
Page 116: ......
