Installing the Equipment
Instruction Manual: evolution 5000 E5500 Mobile Contribution Encoder
Page 2-5
ST.TM.E10033.3
An appliance and cart combination should be moved with care. Quick
stops, excessive force, and uneven surfaces may cause the appliance and
cart combination to overturn.
Do not move or carry the equipment whilst it is still connected to the
supply or other leads, is live or is in operation.
2.3
Installing the Equipment
2.3.1
Read This First!
The MCE must be handled carefully and thoughtfully to prevent safety
hazards and damage. Ensure that the personnel designated to install the
equipment have the appropriate skills and knowledge. If in any doubt,
contact Customer Services.
Installation should be in accordance with the following instructions and
should only use installation accessories recommended by the
manufacturer.
2.3.2
Fixing
Free-standing Installation
The MCE can be installed free-standing. It should be installed on a secure
horizontal surface where it is unlikely to be knocked or its connectors and
leads disturbed. The equipment must be installed and operated in the
normal horizontal orientation, i.e. not inverted or standing on one side.
The MCE must be stationary during operation.
The equipment must not be used as a support for any other equipment.
Rack Mounting
The MCE can be operated mounted in a 19 inch rack. Ensure that it is
firmly and safely located and has an adequate through-flow of air.
Slide the Encoder onto the chassis supports and affix to the rack by means
of an M6 x 18 mm panhead screw in each corner.
Do not use this product as a support for any other equipment.
Figure 2.1: Fitting the MCE into a Rack
Insert screws here to attach
MCE to rack.
Repeat at opposite end of
MCE.
