Operating the Equipment Locally
Instruction Manual: evolution 5000 E5500 Mobile Contribution Encoder
Page 3-111
ST.TM.E10033.3
Fail Relay Test
Press any key (except the Quit softkey) to toggle the
fail relay on and off. Press the Quit softkey to return to
the menu. The relay can usually be heard clicking as it
changes state. The relay is connected to the rear panel
ALARM connector – see Chapter 2, Installing the
Equipment for the connector pin-out details.
Alarm Relay Test Press any key (except the Quit softkey) to toggle the
alarm relay on and off. Press the Quit softkey to return
to the menu. The relay can usually be heard clicking as
it changes state. The relay is connected to the rear
panel ALARM connector – see Chapter 2, Installing the
Equipment for the connector pin-out details.
Alarm LED
Press any key (except the Quit softkey) to toggle the
front panel Alarm LED on and off. Press the Quit
softkey to return to the menu.
3.13
Input Monitor
The Input Monitor display is selected from the
Top Level Menu
(see page
3-34) by pressing the Input Monitor softkey, or from the
Setup/
Operations Menu
(see page 3-23) by pressing the Mon softkey.
The display shows the picture on the currently selected video source, the
audio A and B channel audio levels in the form of bargraphs, the SI service
name, and the video bit-rate. The status of the IF output and modulation
are also shown.
Press the Quit softkey to return to the
Top Level Menu
.
A u t o 1 3. 5 M H z
I F Of f M od Of f
V i d : 2 5. 4 MB i t/ s
A B
Quit
Audio A and B channel audio levels.
Service name.
Status of IF output
and Modulation.
Video bit-rate.
