Operating the Equipment Locally
Instruction Manual: evolution 5000 E5500 Mobile Contribution Encoder
Page 3-21
ST.TM.E10033.3
3.4
Quick Configuration
There are sixteen predefined user configurations. These are a quick and
easy way to configure the MCE without having to enter individual
parameters. From the summary screen press the Cfgs softkey. Then select
the Load Config option (see Load Active Config Option on page
3-31). A list of 16 configurations are shown (refer to Annex D for details of
individual configurations). Select the required one by pressing the
associated softkey. Nothing more need be done. The MCE is now
configured. To go ‘on air’ enable modulation, turn IF on and turn up the
output power in the
Setup/Operations Menu
.
Summary Screen
D e f au l t S er v ic e B ER 9. 9 e- 1 T r k
I F O f f ( -2 0 .0 dB m )
Ops
M o d O f f ( 25 . 60 0 M H z)
Cfgs
P A L -B / G/ H /I N ot Lo c ke d
Help
A u d io O n- O ff
M e nu
D a t a R S2 3 2/ R S4 2 2
3.5
Getting Started
3.5.1
Introduction
This ‘getting started’ section provides advice for new users on configuring
the MCE after power on. Power on (and power off) instructions are
provided in Chapter 2, Installing the Equipment.
3.5.2
Choosing Parameters
Refer to Section 3.2, Navigating the Display Screens for information on
how to use the front panel softkeys and keypad in order to move through
the menu and option screens.
Step 1: Check configuration
Check the
Status Menu
screens to confirm whether the currently set
parameters for each functional area (System, Video, Audio, Data,
Modulator and Mux) meet with requirements. If they do, then the
equipment is ready for operation. The equipment begins generating a valid
transport stream.
If parameters need to be changed, proceed to the next step.
Step 2: Change configuration
If the required parameters are saved as a configuration file, then load the
relevant file.
If the required parameters are not saved as a configuration file:
Set all audio parameters. Enable audio channels, set the coding mode
and standard, bit-rate and all other parameters as required.
Set all data parameters. Enable the data channels and set the
baud-rate/bit-rate as required.
Press the Cfgs
softkey for quick
access to the
Configurations menu
