Introduction
Page 1-16
Instruction Manual: evolution 5000 E5500 Mobile Contribution Encoder
ST.TM.E10033.3
Figure 1.7: Front Panel Indicators
1.4.4
Rear Panel Description
The MCE provides all the connectors at the rear panel. The connectors
depend on whether any of the option modules are fitted. All the
connectors, except the power connector, are physically located on the
separate modules that comprise the MCE. Cutaways in the rear panel
permit access to them. See Figure 1.8.
Figure 1.8: Rear Panel Connectors
NOTE…
The connectors with grey annotations on Figure 1.7 are unused on this model. These connectors are
also listed in Table 2.15 in Chapter 2, Installing the Equipment.
Touch pads, to
select options
ALARM
POWER
Video Compression
Module (tray 1)
Motherboard
(Base Board 3ASI)
(tray 2)
Slots 1-3 (tray 3)
ETHERNET 1 and 2
- data i/p and control
REMOTE CONTROL
IN
HOST STATUS
(engineering use)
SDI - Serial
Data Interface
- video i/p
ASI OUT 1,2,3
HSYNC IN
ALARM
AUDIO IN i/p
Technical Earth
Mains Power
Connection
VCM STATUS
(engineering use)
IF OUTPUTS
(Slot 3)
DATA INPUTS
(Slot 2)
VIDEO INPUTS
(Slot 1)
Slot 4
(blank module)
Information Label 1
Positioned on R/H side
(not shown)
Information Label 2
REMOTE
CONTROL OUT
