Operating the Equipment Locally
Instruction Manual: evolution 5000 E5500 Mobile Contribution Encoder
Page 3-105
ST.TM.E10033.3
NOTE…
For optimum performance the bit-rate given in Table 3.87 is highly recommended as the maximum to
be set. Although it is possible to have higher bit-rates (55.2941 Mbit/s and 60.000 Mbit/s) these may
cause erratic operation.
If the specified bit-rate is outside the valid input range, a confirmation
screen is displayed which shows the maximum/minimum value allowed.
Press the Enter softkey to accept the new value shown, or press the Quit
softkey to leave the original bit-rate unchanged.
Confirmation Screen
Output Bit-rate (204)
Specified Value Too High
Select <Enter> to Set to
Enter
Maximum : 60.0000 Mbit/s
Quit
Host Rate (188) and Host Rate (204) Option
These options refer to the multiplex in the local (host) Encoder.
To change either of the Host bit-rates, press the Host Rate (188) or the
Host Rate (204) softkey in the
Host Menu
.
NOTE…
It would be inappropriate to use the ‘Host Rate (188)’ setting in this configuration, even though it
appears on the menu. Information and references to Host Rate (188) have therefore been excluded
from this section.
The Host Rate (204) can be in the range of 0 Mbit/s to 59.9999 Mbit/s.
Use the keypad or the + and – softkeys to select Host Rate (204) and
then press the Enter softkey after selecting it.
Setup/Mux/Host Edit
Host Bit-rate (204)
+
40.000 Mbit/s
—
Enter
Update using keypad or softkeys
Quit
NOTE…
The host rate cannot exceed the output rate (see page 3-104, O/P Rate (188) and O/P Rate (204)
Option).
Table 3.88: Host Rate (188) and Host Rate (204) Options
Selected Option
Description
204
Min:
0.0000 Mbit/s
Max:
59.9999 Mbit/s
Step Size: 0.0001 Mbit/s
Multiplexer output bit-rate, in 204 byte packets.
Changing the bit-rate affects the automatic video bit-rate and video
resolution calculations.
