Tabor Electronics 5064, User Manual

Page: 364 / 369

A
Appendices
Specifications
A-3
cycle always completed
Burst Upon trigger, outputs a single or multiple pre-
programmed numbers of waveform cycles. (Does
not apply to Sequence Mode). Burst is
programmable from 1 through 1 M cycles
Gated Transition enables or disables generator output.
Last cycle always completed
Mixed Same as triggered except first output cycle is
initiated by a software trigger. Consequent output
requires external triggers through the rear panel
TRIG IN connector
Trigger Characteristics
Trigger Sources
External Rear panel BNC, or front panel manual trigger button
BUS Trigger commands from a remote controller only
Mixed Senses an external trigger first, consecutive triggers
are expected from remote commands only.
External Trigger Input
Impedance 10 k
Ω
Trigger Level Range ±5 V
Resolution 1 mV
Sensitivity 200 mV
Damage Level ±12 V
Frequency Range DC to 5 MHz
Slope Positive/Negative transitions, selectable
Minimum Pulse Width ≥ 10 ns
System Delay
(Trigger input to waveform output)
6 sample clock 150 ns
Trigger Delay
(Trigger input to waveform output)
[(0; 200 ns to 20 s) + system delay]
Resolution 20 ns
Error 6 sample clock 150 ns+ 5% of setting
Re-trigger Delay
(Waveform end to waveform restart)
200 ns to 20 s
Resolution 20 ns
Error 3 sample clock 20 ns + 5% of setting
Trigger Jitter
±
1 sample clock period
Standard Waveforms
Frequency Range
Sine, Square
10 mHz to 80 MHz, Model 2074;
10 mHz to 40 MHz, Model 1074;
10 mHz to 20 MHz, Model 5064
All other waveforms 10 mHz to 20 MHz, some are usable above 20 MHz
Frequency Resolution 11 digits
Accuracy & Stability Same as frequency standard
Sine
Start Phase Range 0 to 360.0
°
Start Phase Resolution 0.1
°
Triangle
Start Phase Range 0 to 360.0
°
Start Phase Resolution 0.1
°
Square