Tabor Electronics 5064, User Manual

Page: 354 / 369

7
Adjustments and Firmware Update
Updating 2074 Firmware
7-23
NOTE
Firmware updates are performed with the LAN set as the
active interface and with the 2074 communicating with the
PC through the network.
To update the 2074 firmware, you will have to run the NETConfig
utility. If you do not have this utility installed on your computer, run the
installation procedure from the enclosed CD. You will not be able to
update firmware without the NETConfig utility. To invoke this utility,
complete the following steps:
1. Turn power OFF on your 2074
2. Click on NETConfig shortcut on the desktop or select Start
»Programs» Tabor Electronics» NETConfig» NETConfig 1.0
The NETConfig window lists Tabor devices found on your subnet.
Figure 7-4 shows an example of this display.
3.
Click on the “Use wait message” to select this option as shown
in Figure 7-4.
Figure 7-4, The NETConfig Utility
4. Turn power ON on your 2074 and observe that the progress bar,
as shown in Figure 7-5, is advancing from left to right. Do not do
anything on the 2074 until the progress bar completes its travel
to the right end.
Tips