Strebel S-WG 100, Installation, Operating And Maintenance Manual, Page: 84 / 125

E09.012.246 Manual S-WG
85
Display message
F9
F l a m e l o s t
p u m p o n 9 9 9 , 5 h r s
Reason Flame detected during normal operation, but was lost while running.
Display message
F10
F a l s e f l a m e s i g n a l
p u m p o n 9 9 9 , 5 h r s
Reason Flame signal is detected while it cannot be expected.
Display message
F11
F a n s p e e d i n c o r r e c t
p u m p o n 9 9 9 , 5 h r s
Reason The controller does not detect a correct fan speed.
Display message
F12
p r o g r a m m i n g e n d
p u m p o n 9 9 9 , 5 h r s
Reason Software parameters have been programmed.
Display message
F13
P a r a m / H a r d w f a u l t
p u m p o n 9 9 9 , 5 h r s
Reason Fault during programming of the water heater software parameters.
Display message
F14
H i g h G a s F a i l
p u m p o n 9 9 9 , 5 h r s
Reason Gas supply pressure is too high.
Display message
F15
C l i x o n F a u l t
p u m p o n 9 9 9 , 5 h r s
Reason Rear wall thermostat (clixon) detects a too high temperature.
Display message
F16
F l o w R e t u r n d t f a u l t
p u m p o n 9 9 9 , 5 h r s
Reason Temperature difference T1-T2 has exceeded the blocking value.
Programmed at the parameters P2 CO, P2 CR until P2 CV.
Display message
F17
W a t e r h i g h l i m i t
p u m p o n 9 9 9 , 5 h r s
Reason
Maximum thermostat (clixon) measured a too high flow temperature.
Display message
F19
S i p h o n s w i t c h
p u m p o n 9 9 9 , 5 h r s
Reason The pressure switch detects a high pressure in the flue/siphon system.