Stratasys P750K, User Manual

Page: 173 / 196

DOC08010 Rev. A (DRAFT 1)
6–57
Stratasys P750K User Guide
External UV meter
The following steps apply when using a stand-alone UV meter. They do
not apply when using the Stratasys UV sensor connected to the printer.
1. When ȱ the ȱ following ȱ screen ȱ appears, ȱ open ȱ the ȱ printer ȱ and ȱ place ȱ the ȱ UV ȱ
sensor ȱ at ȱ the ȱ rear ȱ edge ȱ of ȱ the ȱ tray, ȱ in ȱ the ȱ center.
Figure 6-89: Sensor placement screen
Figure 6-90: Correct UV-sensor placement
2. Lead ȱ the ȱ cable ȱ out ȱ of ȱ the ȱ printer ȱ so ȱ that ȱ you ȱ can ȱ close ȱ the ȱ printer, ȱ and ȱ
make ȱ sure ȱ that ȱ the ȱ cable ȱ will ȱ not ȱ interfere ȱ with ȱ the ȱ moving ȱ print ȱ block.
3. Close ȱ the ȱ printer, ȱ while ȱ checking ȱ that ȱ the ȱ sensor ȱ does ȱ not ȱ move ȱ out ȱ of ȱ
position.
4. Set ȱ the ȱ UV ȱ meter ȱ to ȱ measure ȱ mJ/cm2.
5. Set ȱ the ȱ range ȱ on ȱ the ȱ meter ȱ to ȱ 2,000.
6. Connect ȱ the ȱ cable ȱ from ȱ the ȱ sensor ȱ to ȱ the ȱ UV ȱ meter. ȱ
7. Turn ȱ on ȱ the ȱ UV ȱ meter, ȱ and ȱ wait ȱ until ȱ “0 ȱ 0 ȱ 0.0” ȱ appears ȱ on ȱ the ȱ display.
8. In ȱ the ȱ wizard ȱ screen, ȱ confirm ȱ that ȱ the ȱ sensor ȱ is ȱ positioned ȱ correctly, ȱ
and ȱ click ȱ Next .
Continue with “UV measurement” on page 58.