User Manual of A90 Series Inverter
54
4.2.4
Fault information display mode (
--
E
--
)
In the fault information display mode, press the ENTER key to enter the Level 2 menu.
The Level 2 menu will only display the fault record group under the F19 group, which is
conducive to direct viewing of fault record information.
Press the increment key
or decrement key
on the keyboard in the Level 2
menu under this mode to increase or decrease the function code of the fault group, and the
shift key
will be unavailable. When a fault occurs, you can press the shift key
on the keyboard in the Level 3 menu to switch the display of the fault code, fault output
frequency, fault output current, fault bus voltage, and fault operation status.
4.3
Fault Monitoring
When the inverter is in the fault status, you can directly press the right shift key to
switch the current fault type and the output frequency, output current, output voltage,
running status and working time during the fault.
4.4
Operation Monitoring
In the monitoring status mode 1 of A90, you can set any function code to be viewed
between F12.33 and F12.37. When F12.32=1, the monitoring mode 1 will be enabled. If the
Level 0 monitoring menu appears, you can press the right shift key
to switch the
monitoring parameters according to the order set for each function code between F12.33
and F12.37. When the inverter changes from the stop status to running status, the
monitoring parameter will automatically change from the current value to that indicated by
F12.33. When the inverter changes from the running status to stop status, the monitoring
parameter will automatically change from the current value to that indicated by F12.34.
4.5
Function of M.K Key
When the M.K multi-function key
is pressed, there are multiple response modes,
jog forwarding by default. It is set by the function code F12.00.
4.6
Function of M.K Key
M.K
When the M.K multi-function key is pressed, there are multiple response modes, jog
forwarding by default. As the function code F12.00 changes, the function of this key will
change accordingly.
4.7
Run/Stop
After setting the parameters, press the RUN key
to enable the normal
operation of the inverter, and the STOP/RESET key
to stop the inverter.
