4 S y s t e m S e t u p
4 - 3 6
[ 1 ] I N S T R U C T I O N S F O R U S E
6. Wait approximately 10 minutes for the software to install.
The system indicates advancement of the software installation using the
progress bar at the bottom of the screen.
7. When the system displays the image screen, press the eject button
near the MO drive and remove the MO disk.
8. To change the system language selection (if reset during the software
installation) and then cycle power:
a. Press the eject button near the MO drive and insert the MO disk.
b. Press the
F4
key to display the
Preset Main Menu
and then select
Language/System
on the left of the screen.
c. Select the required language and then select the
Change Language
button.
d. Press the green ON/OFF (
/
) switch to power off the system.
After several minutes, the screen on the system goes dark.
e. When the screen goes dark, press the green ON/OFF (
/
) switch
to power on the system and then follow the on-screen instructions.
9. To cycle power to the system without changing the system language
selection:
a. Press the green ON/OFF (
/
) switch to power off the system.
After several minutes, the screen on the system goes dark.
b. When the screen goes dark, press the green ON/OFF (
/
) switch
to power on the system.
Installation is complete when the system displays the image screen.
Summary of Contents for SONOLINE G50
