4 S y s t e m S e t u p
[ 1 ] I N S T R U C T I O N S F O R U S E
4 - 1 9
To remove a transducer holder:
1. Reach under the holder to locate the tab on the holder.
The tab extends below the point of attachment to the
ultrasound system.
2. Squeeze the tab towards the holder and pull the holder downward.
To install a transducer holder:
Align the support on the holder directly below the point of attachment on
the ultrasound system and firmly push upwards until the holder snaps
into place.
Transducer Cable Management
After you have connected and secured a transducer, drape the transducer
cable through one of the cable hangers located on the sides and front of the
ultrasound system. These hangers provide support for the transducer
cables, keep cables off the floor, and help to prevent tangling of the cables
when more than one transducer is connected to the system.
Summary of Contents for SONOLINE G50
