Siemens SONOLINE G50, Instructions For Use Manual, Page: 155 / 229

4 S y s t e m S e t u p
4 - 1 2
[ 1 ] I N S T R U C T I O N S F O R U S E
Supplying Power to the System
The ultrasound system is powered on and off using the green partial power
on/off (
/
) switch located on the left front of the control panel.
Note: This switch does not completely shut down or disconnect the system from the
power mains. This switch only powers on, or off, a portion of the ultrasound system. To
completely disconnect the system from the power mains, the circuit breaker located on
the back panel must be switched from
I to O .
Caution: Wait approximately 20 seconds between powering the system off
and then on again. This allows the system to complete its shutdown sequence.
To power on the system:
1. Before using the system, perform the Daily Checklist.
2. Verify the power cord is plugged into the system and then into the
power supply.
3. Power on ( ) the ultrasound system.
When powered on, the system runs through a series of self-diagnostic
and calibration tests. The tests last a few minutes, after which the
system is ready for use.
Note: The system will not run through the complete power-on routine if a problem
occurs. Instead, an error code or message appears on the screen to indicate the
problem. Please note the message and call your local Siemens service
representative.
The system is factory-configured to display initially in 2D-mode.
4. Visually check the on-screen displays and lighting indicated in the
Daily Checklist.
To power off the system:
ƒ
Power off ( ) the ultrasound system.
Wait approximately 20 seconds before powering on ( ) the
ultrasound system.
Note: If the C6-3 3D transducer has been operating for longer than 90 minutes, the
system performs a routine maintenance of the transducer prior to powering off. A
message displays on-screen during this procedure.
[1] Instructions for Use
Daily Checklist 4-3