Siemens SIMODRIVE 611A, Installation And Planning Manual

Page: 11 / 329

02.98
0-11

Siemens AG 1998 All Rights reserved 6SN1197–0AA00 02.98 Edition
SIMODRIVE 611 (PJ)
!
Important
The listed filter modules/line filters generate a high discharge current through
the protective conductor. Due to the high discharge current of the filter, there
must be a good permanent connection between the protective conductor of the
filter module/line filter and the cabinet.
The measures according to pr EN 50178/94 Part 5.3.2.1 must be implemented,
e.g.
1. A copper protective conductor with a minimum cross–section of 10mm
2
should be connected or
2. a second conductor should be connected in parallel to the protective con-
ductor through separate terminals.
This cable must fulfill by itself the requirements for protective conductors accor-
ding to IEC 364–5–543.
!
Warning
Operational electrical equipment has parts and components which are at ha-
zardous voltage levels.
Incorrect handling of these units, i. e., not observing the warning information
can therefore result in severe bodily injury or material damage.
Only appropriately qualified personnel may commission/start–up this equip-
ment.
This personnel must have in–depth knowledge regarding all of the warning
information and service instructions according to this Guide.
Perfect and safe operation of this equipment assumes professional transport,
storage, mounting and installation as well as careful operator control and ser-
vice.
Hazardous axis motion can occur when working with the equipment.
Further, all of the valid national, regional and plant/system–specific regulations
must be adhered to.
Note
When handling cables observe the following
they must not be damaged,
they must not be stressed and
they must not come into contact with rotating components.
Note
For IT– and TT supply networks, connected measuring equipment and pro-
grammers must be referred to the reference potential of the module group.
Foreword