Wiring
5.15 Labeling ET 200SP
Distributed I/O system
System Manual, 12/2016, A5E03576849-AG
137
5.15.3
Applying color identification labels
Requirements
The BaseUnits must not be wired when you apply the color identification labels.
Required tools
3 mm screwdriver (only for removing the color identification labels)
Applying color identification labels
Press color identification labels into the terminal box of the BaseUnit.
Note
To remove the color identification labels, you must first disconnect the wiring on the
BaseUnit and then carefully lever the color identification labels out of the holder using a
screwdriver.
①
Module-specific color identification labels (15 mm) for the process terminals (see I/O module
http://support.automation.siemens.com/WW/view/en/55679691/133300
) Manual)
②
Color identification labels (15 mm) for the 10 AUX terminals
③
Color identification labels (15 mm) for the 10 add-on terminals
④
Color identification labels (20 mm) for the 4 AUX terminals
⑤
Color identification labels (20 mm) for the 2 AUX terminals
Figure 5-35 Applying color identification labels
Summary of Contents for Simantic ET200SP
Page 1: ......
