Maintenance
12.2 Changing the type of an I/O module
Distributed I/O system
240
System Manual, 12/2016, A5E03576849-AG
Requirement
Refer to section Application planning (Page 32).
NOTICE
Do not manipulate the coding element
Making changes to the coding element may cause dangerous conditions in your plant
and/or result in damage to the outputs of the ET 200SP distributed I/O system.
To avoid physical damage, do not manipulate the coding.
Changing the type of an I/O module
You have already removed the I/O module.
To make a type change for an I/O module, follow these steps:
1.
Push the coding element out of the BaseUnit using a screwdriver.
2.
Put the coding element back onto the removed I/O module.
3.
Insert the new I/O module (other module type) into the BaseUnit until you hear it click into
place.
4.
Label the new I/O module.
①
Coding element
Figure 12-2 Changing the type of an I/O module
Summary of Contents for Simantic ET200SP
Page 1: ......
